Setting the crossover, the blend between your speakers and subwoofer, will always depend on your room acoustics and your personal preferences.
This is just a recommendation to get you started. From here you can experiment and listen to what effect it has on the sound.
It is also divided into two categories we named AV and Stereo.
The difference is that AV systems have a built-in active crossover which sets the High-Pass and Low-Pass filters on the subwoofer and speaker output. In this combination, you will have to set the internal subwoofer Low-Pass filter to bypass. You can increase your system SPL output substantially by going to a higher crossover point, just don’t go above 120Hz to keep localization to a minimum.
Typically Stereo systems don’t come with active crossovers so you only set the Low-Pass filter on the subwoofer without a High-Pass. This means that your speakers will play the full-range signal with their natural roll-off towards the lower frequencies.
The goal is to find the perfect blend and the smoothest response.
Home Theatre
1961 Series
- 1961 Tower – 80Hz
- 1961 Monitor – 100Hz
- 1961 Center – 100Hz
- 1961 Bookshelf – 100Hz
- 1961 Surround – 100Hz
- 1961 Height – 100Hz
1723 Series S
- 1723 Tower S – 80Hz
- 1723 Monitor S – 80Hz
- 1723 Center S – 80Hz
- 1723 Bookshelf S – 90Hz
- 1723 Surround S – 100Hz
- 1723 Height S – 90Hz
1723 Series
- 1723 Tower – 80Hz
- 1723 Monitor – 80Hz
- 1723 Center – 80Hz
- 1723 Surround – 80Hz
Stereo
1961 Series
- 1961 Tower – 60Hz
- 1961 Monitor – 90Hz
- 1961 Bookshelf – 100Hz
1723 Series S
- 1723 Tower S – 50Hz
- 1723 Monitor S – 60Hz
- 1723 Bookshelf S – 80Hz
1723 Series
- 1723 Tower – 40Hz
- 1723 Monitor – 50Hz
